Peaty's Holeshot CO2 Tyre Inflator


Everyone knows that a straight line is the fastest line! That’s why Peaty's made their Holeshot CO2 tyre inflator straight, rather than bent at 90 degrees. This straight line design enables faster airflow for rapid inflation, and creates less stress on your tubeless valves when you’re using it because you’re coming at the valve straight on rather than at a 90 degree angle.

It's as small and lightweight as possible, so it’s easy to carry in your pocket, bag or strapped to your bike.

Made from CNC’d 6061 aluminium, and with a patent pending valve design, the details of Peaty's inflator heads have been agonised on - from the exact rubber compound of the o-rings to the awesome Chris King anodized colours.

Not stopping at the inflator head, Peaty's applied the same level of detail and quality in making a high quality CO2 cartridge sleeve. far from a cheap strip of neoprene, our freeze protector sleeve is made from temperature resistant silicone and has a unique closed base to stop your hand from freezing to the cartridge, no matter how you hold it - even without wearing gloves.


Content:
- 1 x Red, 16g
- 1 x Gold, 16g
- 1 x Emerald, 16g
- 1 x Punch, 16g
- 1 x Turquoise, 16g
- 1 x Mango, 16g
- 1 x Violet, 25g
- 1 x Black, 25g
- 1 x Bourbon, 25g
- 1 x Slate, 25g
- 1 x Silver, 25g
- 1 x Navy, 25g


Key Features:
- Available in 12x Chris King colours
- Unique Patent Pending compact straightline design for maximum airflow
- Simply push down to inflate
- Unique closed base silicone Freeze protector sleeve prevents your hands from freezing, even without gloves
- Each kit contains 1x inflator head, 2x CO2 cartridges and 1x freeze protector sleeve


Please read all instructions before first use.

- Make sure CO2 gas is fully discharged after each use by pushing head several times against a hard temperature-resistant surface
- Fits all 16g / 25g threaded cartridges
- Always use the CO2 sleeve supplied to protect hands from extreme cold during inflation
- Always carry CO2 Cartridges separate from the inflator head to prevent accidental discharge in transit


Warning
1. Do not use with CO2 cartridges over 25g.
2. If using multiple CO2 cartridges in one session, wait 30 seconds between each cartridge to prevent ice build-up in the inflator head.
3. Ensure the inflator head is fully threaded onto the CO2 cartridge before use. Failure to secure tightly will cause improper operation and may cause injury.
4. Test the cartridge is fully pierced before use by briefly pressing the head down onto a hard, temperature resistant surface and ensure a high flow of CO2 being discharged from the inflator head.
5. Do not remove the CO2 cartridge until it is fully discharged.
6. Check CO2 gas is fully discharged after each use by pushing head several times against a hard temperature-resistant surface.
7. Point away from yourself and others while using.
8. Do not use if any part is cracked or damaged.
9. Do not expose the CO2 cartridge to heat, store at temperatures above 49C (120F), or store in enclosed vehicles.
10. Make sure to wear gloves when inflating to avoid injury.
11. The inflator head and CO2 cartridge will become very cold/frosty when the CO2 gas is expelled. Do not unscrew the used cartridge until it has warmed enough to touch.
12. Keep out of reach of children.