Peaty's Monarch Grip Lock Ring


Our replacement Monarch grip lockrings are available in twelve anodised colour options, are made from 6061 aluminium and come with preinstalled 3mm stainless steel allen keys bolts. Torque bolts to a maximum of 3Nm.


What's included?
- Two lockrings with 3mm allen key bolts
- Slimline 8mm wide clamp to maximise grip area
- 6061 Aluminium lock rings with stainless steel bolts
- Available in twelve colour options
- Left and right markings on each clamp
- Cardboard backing board and securely held in place with paper locking wire

Fitting instructions:
- 1) Loosen 3mm allenkey on lockring.
- 2) Remove Monarch grips from bars and pull off old lockrings.
- 3) Re-fit new clamps, ensuring the correct side is fitted to the correct grip using the L & R markings engraved above the allen key.
- 4) When fitted correctly, the flat edge of the lockring should touch the rubber of the grip and allenkey facing the rider.
- 5) Re-fit grips, following our grip application steps.
- 6) Ride!